Bob Smith Industries Insta-Cure + CA Super Glue - 1oz

$6.99

Bob Smith Industries' (BSI) Insta-Cure Plus CA Super Glue is a thicker adhesive that won't run excessively during application. Sold in 1oz bottles.

Product Options

Frequently Purchased Together

Bob Smith Industries QUIK-CURE 5 Minute Epoxy - 4.5oz

Bob Smith Industries QUIK-CURE 5 Minute Epoxy - 4.5oz

$13.99
Bob Smith Industries Insta-Clean Sticker/Adhesive Remover - 2 FL. oz

Bob Smith Industries Insta-Clean Sticker/Adhesive Remover - 2 FL. oz

$4.99
Loctite Threadlocker 242 - Medium Blue - 6mL

Loctite Threadlocker 242 - Medium Blue - 6mL

$8.69
Loctite Threadlocker 222ms - Low Strength - Purple - Mil Spec - 6mL

Loctite Threadlocker 222ms - Low Strength - Purple - Mil Spec - 6mL

$7.19
Bob Smith Industries Insta-Cure Super Thin CA Super Glue - 1oz

Bob Smith Industries Insta-Cure Super Thin CA Super Glue - 1oz

$6.99
Bob Smith Industries Maxi-Cure Extra Thick CA Super Glue - 1oz

Bob Smith Industries Maxi-Cure Extra Thick CA Super Glue - 1oz

$6.99
Quantity
Ready To Ship

Close

Bob Smith Industries Insta-Cure + CA Super Glue - 1oz

Bob Smith Industries' (BSI) Insta-Cure Plus CA Super Glue is a thicker adhesive that won't run excessively during application. Sold in 1oz bottles.

Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ ™ should also be used. To prevent premature curing, don’t spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out.

Works Best On:

Balsa Wood

Soft Wood

Works Well On:

Hard Wood

Glass

Metals

Fiberglass

Ceramics

Hard Plastics

Rubber

Directions:

Unscrew top from nozzle. For finer applications, use the extender tip. Apply Insta-Cure+™ CA to one side of the parts being joined, then hold them tightly together for 5-15 seconds. For larger bonding areas, apply serpentine beads of the CA with enough spacing to allow for the spreading of the adhesive. Insta-Set™ accelerator can be sprayed to cure the CA that oozes from joints. Full strength is reached in three hours. Wipe the nozzle clean before replacing screw-on top. Refrigerate to extend shelf life. Cured CA is stable from -40 to 220° F. Soak extender tip in acetone for cleaning.

BSI-107
10 Items

You might also like