- New
Shipping is free with 150$ purchases! Contiguous US only. Same day shipping cut-off -- 2PM EST
Menu
Menu
BIQU Panda Breath Smart Air Filtration and Heating System for Bambu Lab 3D Printers
$99.99
The BIQU Panda Breath is a smart 300W chamber heater and HEPA air filtration system for Bambu Lab and Klipper based 3D printers. It reduces warping, filters VOCs and fumes, and doubles as a filament dryer when idle.
BIQU Panda Breath Smart Air Filtration and Heating System for Bambu Lab 3D Printers
The BIQU Panda Breath is a smart chamber heater and air filtration system for Bambu Lab P1S, P1P, X1C, and A1 (with Panda Shelter), as well as Klipper based 3D printers. Its 300W PTC heater delivers uniform chamber temperatures up to 60°C, reduces warping and cracking for filaments like ABS, ASA, PC, and PA while improving layer adhesion across all materials.
The built-in HEPA and activated carbon filter captures VOCs and fine particles for safer, odor free printing. Panda Breath starts and stops automatically based on bed temperature, just set the thresholds via web UI. When not printing, use filament drying mode to remove moisture from your spools without extra equipment!
For installation instructions and configuration details, visit the BTT Panda Breath Wiki page.
Frequently Asked Questions
- Which 3D printers is the BIQU Panda Breath compatible with?
- The Bambu Lab P1S, P1P, and X1C are fully supported. The A1 is also compatible when used with the Panda Shelter enclosure. Klipper-based printers like Voron and Snapmaker U1 are also supported with manual control (automatic start/stop coming via firmware update).
- How often do I need to replace the filter?
- BIQU recommends replacing the HEPA + activated carbon filter every 3 to 6 months depending on usage.
- Can the BIQU Panda Breath dry filament?
- Yes! When your printer is idle, you can switch to filament drying mode to use the heated chamber as a filament dryer without needing separate equipment.
BIQU-PANDA-BREATH
14 Items
You might also like
The BIQU Panda Breath is a smart 300W chamber heater and HEPA air filtration system for Bambu Lab and Klipper based 3D printers. It reduces warping, filters VOCs and fumes, and doubles as a filament dryer when idle.