Mandala Rose Works Kinematic Bed Upgrade System for Sovol SV08

The Sovol SV08 printer is a very economical printer, but users have had issues with the waviness of the beds.  We have created the Sovol SV08 Bed Adapter which makes use of our Voron 350 Beds and gives you a kinematically mounted bed replacement solution for the SV08!

Our default configuration is the Voron 350 Ultraflat bed (flat to no more than 0.1mm out of flat), but you have the option to upgrade to the Voron 350 Magbed as well (also flat to no more than 0.1mm out of flat). Please note, the magnets can and will interfere with a number of probes on the market. 

Options:

Ultraflat: Use a standard magnet sheet for flex plate retention

Ultraflat Mag Bed: Use in-built magnets allowing the omission of a standard magnet sheet

MagBed Features:

Superior plate holding power from top-side mounted magnets

No more adhesive magnet sheets - You'll enjoy higher plate holding power at all temperatures

Magnet sheets can not be ground flat. Omitting them keeps your final deviation where you want it

Includes:

3 150C N48SH Magnets

3 Pin Mounts

Adapter Plate

12 Button Head m3x6mm Bolts

3 Button Head m3x10mm Bolts

3 Internally Threaded Balls for the Kinematic Mounting

2 Cap Head m3x20mm bolts used to lock the bed to the adapter plate if you have to flip your printer to work on it.

Not Included:

The STL for increasing the height of the nozzle touch off button is here. You will also need (2) M3x20 or longer screws to mount the touch off button with this riser.

This bed is pre-assembled using the hardware listed above, you just need to supply the heater and magnet sticker (if you do not order the magbed).  Mounting the bed is done with the hardware from the original bed.

The magnets on the adapter plate help keep the kinematic balls in the channels, and it takes over 3000g of force to dislodge the bed from the adapter plate, so Tap will work just fine with this system.

Dimensions:

- Bed: 355mm x 355mm x 9mm

- Adapter: 370mm x 370mm x 11mm (with the pin mounts installed)