HyperLok High-Temp 3D Printer Bed Adhesive - 50mL

Documentation and Instructions (including MSDS) here!

3DPrinting.com Article here!

KPD’s Hyperlok Adhesive is the perfect solution for all of your Industrial 3D Printing needs. Formulated to work at high temperatures, making it easier than ever to print Industrial, high temperature Polymers.

APPROVED BUILD SURFACES

    Carbon Fiber

    Garolite/Bakelite

    PEI Sheet

    PEI Powder Coated

    PEEK Plate

    Steel Sheet (TPU/Flex ONLY)

UNSUPPORTED BUILD SURFACES

    Glass Plate

    Plastic Textured Film/BuildTak

    Polypropylene (Un-Tested)

EASY TO USE!

⚠️Clean with Plate Removed from Machine, do NOT spray Cleaner inside of Machines!

    Mix 50/50 Isopropyl Alcohol/H2O Solution in a spray bottle with MicroFiber or Dust Free Towel.

    Let soak for 10 Seconds and wipe off.

    Repeat Steps 1 & 2, wipe with new towel, or clean side.

    Visually Inspect to verify Plate is clean

⚠️Ensure Plate is COOL, do NOT apply when HOT!

⚠️Make sure Z-Offset is Correct.

    Apply roughly a Quarter-Sized amount for every 250 x 250mm Area.

    Spread slowly and evenly with the included Silicone Brush in a circular motion to distribute evenly.

    Turn Brush on its side width-wise and spread in a criss-cross pattern until evenly coated.

    Let dry for 2-3 minutes before heating the bed.

    Relax! Your parts will be HyperLok'd to your surface.

    Let your Parts cool fully in the build Chamber before removing.

    Clean fully between coats, each surface will last multiple prints.