Nudge - Hardware Pack - Automatic Nozzle Alignment

Build your own high-precision Nudge probe with a curated hardware pack. This kit contains all the mechanical components needed to assemble the standard Nudge automatic nozzle alignment system for your multi-toolhead 3D printer. Just add your 3D printed parts for perfect toolhead alignment.

Key Features

• Precision: Single-microstep repeatability - typically below .003125mm standard deviation
• Minimal Travel Loss: Probe tip fits next to the bed - as little as 6mm overtravel
• No Special Tools: No heat sets, soldering or glue required
• Fast Setup: Print, build and test your Nudge probe in under an hour
• Enclosure Compatible: No electronics to overheat at chamber temperatures, and no plastic near heat sources

Mounting Options

2020

Aligned to the bottom of 2020 extrusion. Compatible with the Voron Trident, V2, etc.

1515 High

Aligned to the bottom of 1515 extrusion. Compatible with the F-Zero, Micron, etc.

1515 Low

Aligned to the top of 1515 extrusion. Compatible with the Tri-Zero, Pandora, etc.

Kit Contents

• (1x) 5-30mm Bearing Steel Pin
• (6x) 6x3mm N35 Neodymium Magnets
• (1x) M3x10mm Socket Head Cap Screw
• (2x) M3x12mm Socket Head Cap Screws
• (6x) M3x6mm Socket Head Cap Screws (Copper)
• (3x) M3x6mm Button Head Cap Screws (Copper)
• (1x) M3 Nut
• (1x) 2-pin JST-XH male connector w/ pins and housing

The Nudge Hardware Pack is based on the latest bill of materials for an extrusion mounted probe. Not compatible with floating and indexed bases.
Note: 3D printed parts are not included. STL files are available through the official Nudge Github repository.