Shipping is free with 150$ purchases! Contiguous US only. Same day shipping cut-off -- 2PM EST
Menu
Menu
Linneo Raspberry Pi PCB Hat Board - For 30mm Fans
$13.79
This PCB is offered by Linneo as a safe and easy way to interface with the power inlet and input shaping pins of a Raspberry Pi SBC in 3D printing applications and features provisions for a 30mm cooling fan.
Linneo Raspberry Pi PCB Hat Board - For 30mm Fans
This PCB is offered by Linneo as a safe and easy way to interface with the power inlet and input shaping pins of a Raspberry Pi SBC in 3D printing applications and features provisions for a 30mm cooling fan.
Features:
Powered from original Molex connectors (5A rated), safer than crimped "Dupont" connectors on the pins. Note that an RPi 4 and 5 might use up to 4A while some other connectors often used in this application are not rated for more than 2A.
Fan cooling port for 5V 30x30mm fans. This port receives 3.3V so the fan runs a bit slower and silent.
ADXL345 easy connection, compatible with LINNEO ADXL harnesses. (Using the same pin order as in the GPIO pins for easier DIY ADXL cables.
Includes crimped FEP power cables to use with a 5V PSU.
Linneo
LIN-PCB-PI-FAN
You might also like
This PCB is offered by Linneo as a safe and easy way to interface with the power inlet and input shaping pins of a Raspberry Pi SBC in 3D printing applications and features provisions for a 30mm cooling fan.