Bondtech's CHT™ nozzles for Volcano split the filament into 3 thinner strands allowing to melt the material from within. In doing so, the material melts faster and higher flow rates can be realized. Made of nickel coated brass.
See this blog post from Bondtech to avoid damaging your new CHT nozzles!
E3D Volcano blocks
Other Volcano type blocks
Artillery Sidewinder X1 and X2
Anycubic Vyper
FLSUN Super Racer
Artillery Genius Pro
Anycubic Kobra and Kobra Max
Lulzbot TAZ MOARstruder
Others compatible with Volcano…
Bondtech CHT™ nozzles split the filament into 3 thinner strands allowing to melt the material from within. In doing so, the material melts faster and higher flow rates can be used.
A Nickel coating is applied to our Coated Brass nozzles to provide protection against corrosion, erosion, and abrasion. Nickel coated nozzles have more corrosion resistance and lower coefficient of friction, which allows slicker feeding of material and delays plastic adhesion to the nozzle’s surface.
Use this nozzle with the following materials:
For technical and abrasive materials we recommend to use other nozzles in our range.
We recommend you to have several sets of nozzles because:
Using different materials with the same nozzles causes deposit build-up inside the nozzle.
These deposits will cause blockages.
We recommend changing nozzles when changing materials.
Specific References
You might also like
Bondtech's CHT™ nozzles for Volcano split the filament into 3 thinner strands allowing to melt the material from within. In doing so, the material melts faster and higher flow rates can be realized. Made of nickel coated brass.
