- New
Shipping is free with 150$ purchases! Contiguous US only. Same day shipping cut-off -- 2PM EST
Menu
Micro Swiss FlowTech Hotend for Anycubic Kobra S1
$84.95
The Micro Swiss FlowTech hotend for the Anycubic Kobra S1 offers plug 'n play installation, a sealed heater core, and cold nozzle swaps. Includes a genuine Bondtech CHT CM2 0.4mm high flow nozzle rated up to 320°C.
Micro Swiss FlowTech Hotend for Anycubic Kobra S1
The Micro Swiss FlowTech hotend for the Anycubic Kobra S1 is a complete all-metal hotend upgrade with plug 'n play installation and genuine Bondtech CHT high flow performance included.
This complete hotend upgrade features a sealed heater core for better performance, and an entire ecosystem of high-performance, leak proof nozzles. Paired with a genuine Bondtech CHT High Flow nozzle, it delivers volumetric flow rates up to 50 mm³/sec for ultra-fast printing without compromising quality. The all-metal construction supports printing temperatures up to 320°C with a matched NTC thermistor that just works, no firmware changes needed. It also offers effortless cold nozzle changes without heat tightening.
Made in the USA by Micro Swiss
Sealed Heater Core
In contrast to the stock heater core, the FlowTech hotend uses a fully sealed design:
- Enhanced Heat Retention: The sealed design efficiently traps heat within the core, ensuring stable and consistent printing temperatures.
- Increased Durability: By protecting the heating element and thermistor, the sealed heater core reduces the risk of damage, extending the lifespan of the hotend.
CHT High Flow Performance
An official collaboration between Micro Swiss and Bondtech brings the CHT High Flow nozzle to the FlowTech ecosystem, included with this hotend.
- High Flow CHT: Equipped with Bondtech CHT technology, the included nozzle achieves a maximum volumetric flow rate of up to 50 mm³/sec.
- Better Layer Adhesion: More uniform layer deposition is achieved by splitting the filament flow into multiple chambers as it passes through the melt zone. This reduces gaps and weak points between layers.
Leak-Proof Nozzle
Every FlowTech nozzle integrates the nozzle tip and titanium heatbreak into one sealed unit, eliminating the gap where leaks typically occur.
Cold Nozzle Change
With the heatbreak built into each FlowTech nozzle, swaps can be done at room temperature. No hot tightening, no tools, just unscrew and replace with one hand.
FlowTech Nozzle Ecosystem
Fully compatible with the growing FlowTech ecosystem, offering a wide range of nozzle options:
Compatibility
- Anycubic Kobra S1
What's in the Box
- (1×) FlowTech 24V 60W Heater Core
- (1×) FlowTech CM2 CHT 0.4mm Nozzle
- (1×) Heatsink for Anycubic Kobra S1
- (2×) Titanium Screws
- (1×) Silicone Sock
Volumetric Flow Rate Analysis
PLA
10 mm³/s 20 mm³/s 31 mm³/s 41 mm³/s
M3114
5 Items
You might also like
The Micro Swiss FlowTech hotend for the Anycubic Kobra S1 offers plug 'n play installation, a sealed heater core, and cold nozzle swaps. Includes a genuine Bondtech CHT CM2 0.4mm high flow nozzle rated up to 320°C.