This silicone heater from Keenovo measures 180mm x 180mm square and offers 300W of heating power at 120V. For use with the Micron+ 3D Printer (180). It comes standard with a high temperature 3m adhesive backing. Includes integrated NTC 100k thermistor.
This silicone heater from Keenovo measures 180mm x 180mm square and offers 300W of heating power at 120V. For use with the Micron+ 3D Printer (180). It comes standard with a high temperature 3m adhesive backing. Includes integrated NTC 100k thermistor.
Notes From Keenovo:
Heaters may get super hot. Please handle with care.
Red wires are the Thermistor sensor extension wires, white wires are for voltage supply to the heating element.
A supporting frame/layer is strongly suggested to have the heating element "sandwiched" tightly for better heating result.
If your heater comes with Keenovo Digital Controller, please read the Controller Configuration Manual, especially the "Advanced Setting" part, carefully BEFORE making any changes on the controller.
The controller unit is 100% brand new. Yet due to manufacturing reasons, stains, dusts or scratches may be present on the silicone case. It may also fit less tight as shown in the picture. Please consider this before the purchase.
As we receive customer feedback, we do make small alterations to our products if we feel they improve the their performance and stability. The item(s) you receive might reflect some of these slight changes and improvements.