

This PCB is designed for use as a serviceable splice point for wiring up to 5 12/24 Volt fans in parallel. Useful for 3D printers requiring additional part cooling or enclosure heat.
This PCB is designed for use as a serviceable splice point for wiring up to 5 12/24 Volt fans in parallel. Useful for 3D printers requiring additional part cooling or enclosure heat.
Check out Orangetruth's printed mount/spacer here!
Up to 5 12V or 24V fans controlled by a single controller output
Easily serviced - Or add fans as you need them
2 Pin JST-XH headers
Mounts to 2020 extrusion
This PCB is designed for use as a serviceable splice point for wiring up to 5 12/24 Volt fans in parallel. Useful for 3D printers requiring additional part cooling or enclosure heat.