E3D Rapid Change Revo CR Hotend - Creality - 24V

· Upgrade your Creality 3D printer to Revo so you can change nozzles cold without special tools and hot tightening hassles

· No extra mounts or adapters needed: Pre-drilled M3 clearance holes match Creality’s X carriage mounting pattern for easy installation

· No firmware tweaks - This kit includes a special Revo HeaterCore with a 100K NTC thermistor, which has the same response as the stock Creality thermistor

· Includes solderless, crimpless, butt splice connectors for easy connection. Wire the HeaterCore into your Creality 3D printer without undoing your entire cable bundle

· Detailed [upgrade guides] created by us help you get 3D printing quickly

Creality mounting holes:

Convenient M3 clearance holes correspond to Creality’s X carriage mounting pattern, so you can get up and running quickly without extra mounts or adaptors. Just reuse the existing M3 bolts!

Easy nozzle swaps:

A variety of Revo Nozzles enhance the capabilities of your 3D printer without a difficult nozzle changing processes. Every Revo Nozzle can be changed by hand. No tools, no hot tightening.

Simple, hassle-free connection:

We’ve included some solderless, crimpless, butt splice connectors for easy connection to help you get up and running quickly without having to undo your entire wiring bundle.

Better reliability:

Revo Nozzles are factory sealed, so there’s much less chance of nozzle leaks, and no hot tightening needed.

Better efficiency:

The included Revo HeaterCore makes your 3D printer heat up faster and more efficiently than the stock HotEnd. Start 3D printing right away without annoying firmware adjustments: we’ve integrated a 100K NTC thermistor into this special HeaterCore. This thermistor has the same response as the stock HotEnd, so no firmware tweaks are needed.

Better safety:

Thanks to built-in PTC behavior of the heater, Revo CR will add an extra failsafe against thermal runaways to your Creality 3D printer – providing an extra layer of protection if thermal runaway protection is disabled in firmware.

Revo CR is directly compatible with the following Creality 3D printers:

Ender 3

Ender 3 Pro

Ender 3 V2

Ender 5

Ender 5 Pro

Ender 5 Plus

Ender 6

CR10

CR10S

CR10S4

CR10S5

Please note:

- Revo CR can be used with other Creality printers using the NTC thermistor, however you may need to make modifications to the mount and or Z sensor.

- You may need to adjust the Z height when changing nozzles.

- Please check whether your specific printer runs 12V or 24V before purchasing and assembling.

Key features:

- Max temp: 300°C

- Works with Revo HeaterCore and Revo Nozzles

- Includes solderless, crimpless, butt splice connectors for easy connection

- 100K NTC thermistor embedded in this Revo HeaterCore

Kit Features:

- 5 x butt splice connectors

- 1 x Revo CR HeaterCore:

· Embedded 24V 40W heater cartridge

· Embedded 100K NTC thermistor

1x Revo HeaterCore spring

Note: M3 bolts not provided

Material compatibility: 1.75mm

Mount system: Flat mounting, pre-drilled M3 clearance holes that match Creality mounting pattern

Voltage: 24V

Dimensions:

Height: 59.10mm

Diameter: 22mm