BIGTREETECH Eddy Coil V1.0 Auto Bed Leveling Sensor

The BIGTREETECH Eddy Coil V1.0 is a cutting-edge leveling sensor designed exclusively for Klipper, ensuring ultra-fast leveling in as little as 20 seconds, even on large-sized FDM printers. Weighing just 6g, it minimizes impact during operation while offering precise 0.0005mm leveling accuracy. The Eddy Coil is compatible with BTT EBB36/42 CAN tool boards, making it easy to integrate into your 3D printing setup. With a worry-free installation and anti-fooling design, this sensor is perfect for users seeking efficient, high-precision bed leveling.

BIGTREETECH Eddy Coil Auto Bed Leveling Tool

Perfect Fit for Voron 2.4 Stealthburner

BIGTREETECH Eddy Coil only supports Klipper. It needs to be used with tool boards with I2C interfaces such as BTT EBB36/42 CAN, and BTT has configured customized DuPont female connector cable for you. (Eddy Coil+EBB36/42 CAN=Eddy USB)

Notes: BTT Eddy Coil must run on metal spring steel plates to avoid interference from independent magnets. If the hot bed uses a circular magnet scheme, it will cause eddy coil to not work properly. A hot bed scheme with PEI steel plate and soft magnet can be used.

Featherlight

BIGTREETECH Eddy Coil V1.0, lightweight and compact, with strong compatibility. The weight is as low as 6g, effectively reducing the impact of exercise.

Rapid Leveling Speed

BIGTREETECH Eddy Coil V1.0 only takes 20 seconds or less to heat the bed, saving waiting time and providing a better 3D printing experience.

High Precision

Customized casing can effectively shield external metal interference, facilitate installation, improve user experience, and ensure precise leveling of 0.0005mm.

For Voron StealthBurner

BIGTREETECH Eddy Coil V1.0 can be effortlessly attached to the TL-Q5MC2(PL-08N) location for quick and convenient integration.

For H2 Series Extruders

BIGTREETECH Eddy Coil V1.0 can be attached to the BIQU H2 series extruders with the provided mounting screws for printing leveling.

For Ender-3

BIGTREETECH Eddy Coil V1.0 can be attached to the Ender-3 with the provided mounting screws for printing leveling.