- Pack

The Bondtech DDX Direct Drive eXtruder for Creality 3D printers is an upgrade kit that replaces the original bowden with a direct drive setup. It is a high-performance Dual Drive extruder based on the BMG Bondtech Mini Geared. This pack includes the DDX V3 and an adapter set for fitting to a Creality CR-10 V2 or V3 3D printer.
To use the DDX V3 on the CR-10 V2 & V3, a Slice Engineering Copperhead or Mosquito or Mosquito Magnum is required.
The DDX V3 is much easier to install
With this integrated fan shroud and mount the DDX V3 is even easier to install.
Snap the fan to the shroud without using screws.
Adjust the height of the shroud with one front access screw.
Using a bed probe with DDX v3
The DDX was designed to allow space for the bed probe to be attached to the x-carriage. In models where there is no space to attach a bed probe like the BLtouch, to the X-carriage, a mount can printed and attached to the right hand side of the DDX v3.
Bondtech DDX v3 Direct Drive eXtruder
This Direct Drive eXtruder from Bondtech is a high performance, high reliability 1,75mm Dual Drive extruder for Creality 3D printers, based on our very popular BMG. Bondtech’s unique Dual-Drive technology combined with either the factory hotend or for even better performance the industry leading hotends Copperhead or Mosquito from Slice Engineering, gives you a direct drive extruder with trouble free material feeding and enables the use of a wider range of materials. The housing parts are printed with PA12 (polyamide) for maximum strength and precision using industrial grade SLS technology.
Make your 3D printer even better
Bondtech DDX v3 Direct Drive eXtruder for Creality is designed to give the user more options – different materials; higher flow and/or wider nozzles; thinner layers – and achieve a higher print quality. The DDX v3 is based on the BMG Bondtech Mini Geared extruder featuring our unique Dual-Drive technology. The DDX v3 housing design provides an effective Hot-End cooling. With the 3:1 gearing ratio, high resolution prints with small nozzles or high flow prints with bigger nozzles can be achieved.
Easy To Setup
For ease of setup the kit is attached to the carriage with only 2 screws.
Product includes:
1x DDX v3 Extruder
1x Nema17 Pancake stepper motor
1x Thumbscrew Assembly
1x 70cm Stepper motor extension cable
1x 60cm PTFE tube
1x 7cm Capricorn tube
4x Zip-ties
3x M3x12mm screw
2x M3x20mm screw
1x M3x10mm button head screw
1x M3 square nut
1x 10079-5 DDX v3 5015 Fan Shroud
1x 10079-65 DDX Mount Plate for CR-10 v2;
1x 10079-45 DDX Bowden Mount
1x 10079-80 DDX Z-Sensor Plate for CR-120 v2
6x M3 Square Nut;
2x M3x25 Screw;
1x M3x20 Screw;
2x M3x8 Screw;
1x M3x12 Screw;
1x M3x10 button head screw
You might also like