CNCKitchen Volcano to V6 Nozzle Adapter - V2

CNCKitchen's Volcano to V6 Nozzle adapter allows the use of a standard V6 nozzle with your Volcano hot block! Machined from lead and cadmium free brass alloy.

Features:

Improved Design for Hot-Tightening, incl. 2mm Hex Key

Use any standard length V6 nozzle on a printer with volcano hot end

Usable up to 300°C

Suitable for all materials, even abrasive ones (CF, wood, glow in the dark)

No change of print settings is necessary

Note: Harder to purge than a standard nozzle. Consider cold-pulling when regularly changing colors or materials!

Cold pulls are still possible

Lead & Cadmium free brass alloy

Intended Use:

This brass adapter can be used to install any standard length V6 into a Volcano heater block. It bridges the 8.5 mm length difference between standard and volcano nozzles. This way, you don’t need separate nozzles for your different hotends. All standard nozzles will now also fit a Volcano heater block.

Installation:

Stick the adapter onto a 2.0 mm Straight Hex Key and carefully screw it into the HOT heater block from the bottom. The temperature should be at least your usual printing temperature. Please don’t use a Ball End Hex Key because that can strip the hex in the adapter. Tighten it carefully to around 0.5 – 1.0 Nm. Install your standard length V6 nozzle as usual.

Make sure there is a small gap between the nozzle and the heater block. This ensures that you tightened the nozzle against the adapter and not the heater block. Otherwise, plastic might leak through the threads.

Credits:

This adapter is based on an idea from Nitram who is the father of the VolcoMosq heater block!