

Compact, feature packed, and designed with Voron in mind, the FYSETC Spider offers flexibility and plenty of power with a small foot print. Supports up to 8 stepper motors at up to 60 volts via a range of compatible drivers in UART/SPI modes. Compatible with Marlin & Klipper.
TMC 2209 Drivers Here
RGB Displays Here
HV5160 Drivers Here
Compact size: 155.3mm x 76.5mm
Based on STM32F446 180Mhz,all IOs can withstand 5V voltage
8 TMC stepper drivers support, with Uart&SPI support
Improved TMC jumper settings again,simpler and easier
28V input max,12V@5A DC-DC,5V@8A DC-DC (Especially for Raspberry Pi),3.3V@0.8A LDO
Two car fuses for hot bed input and main power input
Limit switch socket 24V/5V/3.3V optional, ready for more other equipment, such as -inductive sensor, BL-Touch
XH2.54 connectors
10x PWM capable power mosfet outputs (1 for HotBed, 3 for Heat-End, 3 for fans, 3 for RGB LED strip)
3pin temperature header, you can use thermistor or thermocouple (requires AD597 module)
Up to 8 ways PWM fans (only use 1 extrueder and no 12V/24V RGB used ),2 ways RGB led(12V & 24V optional) ,1 way 5V-RGB led (NEO-PIXEL/WS2812)
RepRapDiscount SmartController compatible pin header on board
UART1-Raspberry Pi pin header (including 5V@8A power supply)
2X4 PinHeader Out for SD Card moudle
Onboard micro-SD card
Type-C and Type-B USB connector optional
EXP1 & EXP2 have more multiplexing functions, such as USART, I2C, CAN
SD card & USB upload support
A 4.7kOhm 0.1% temperature sensor pull up resistor is used, PT1000 can be connected directly. For PT100, an amplifier board must be used.
You might also like